The very popular SW-AB-LONG AEG MOSFET switch has active braking, built-in automatically resetting thermal fuse, pre-attached wires, and fits in the present fuse holder space. ($55.00)

Specifications:

Size = 0.6 x 0.5 x 2.0 inches

Fuse Current = 20 Amps

Voltage = 8 to 16 VDC

Peak Current = 160 Amps

Active breaking time = 100mS

Features:

1. Full active braking that is gentle enough not to harm the motor but still stops the motor very quickly.

2. Fully assembled, production tested, and serial numbered.

3. Built in 20 amp automatically resetting thermal fuse.

4. All wires supplied and attached to the PC board.

5. Built in heatsink.

6. The MOSFETs are fully protected against voltage spikes from the motor.

7. It is almost impossible to cross conduct the MOSFETs.

8. Fully protected against static discharge.

9. Advanced break timing circuit.

10. The circuit draws no current when not triggered.

11. The trigger circuit needs considerable current to turn on preventing false firing from condensation, grease, etc.

12. Uses surface mount parts to minimize size.

13. Very tolerant of bad wiring, bad layout, noise, etc.

14. Failure of the active breaking MOSFET can't turn the gun uncontrollably on.

15. New low heating trip circuit prevents damage under very long term short circuit conditions.

Documents:

SW-AB-LONG-Description.pdf

SW-AB-LONG-Instructions.pdf

Accessories:

Connectors

For any questions please contact    sales@extreme-fire.com

Special Note: These products assume the buyer is able to disassemble and reassemble the AEG andespecially the mechbox fairly easily. Rewiring and soldering are needed for installation as well as some electrical and mechanical skills.